Ceramic Tile Adhesive C1

This product is a high-quality polymer modified dry mortar, and its adhesive performance is far superior to that of traditional cement adhesive materials. It has passed the China Ten Ring Certification and the French A+ indoor certification, and is a green and environmentally friendly product.

--Packing specification: 20KG

--Executive standard: JC/T547-2017 "Ceramic Tile Adhesive" C1

--Product advantages: strong adhesion, not easy to hollow, thin adhesive layer, light weight, low dosage.

Product Information

Product features: 1. The product has high strength, the national standard strength requires 0.50MPa, and the product can reach 0.6-0.9MPa.

2. Stable quality, good anti-seepage performance, heat aging resistance;

3. Just add water, simple and easy to use;

4. Strong adhesion, fast hardening speed, not easy to hollow drum;

5. The paste layer is thin, the weight is light, and the dosage is small.                                 

Main ingredients: Portland cement, refined sand, imported rubber powder and functional additives.

Scope of application: porcelain tiles, ceramic tiles, mosaics, etc., the side length of the pasted ceramic tile specifications ≤ 800mm.

Theoretical dosage: 5~6kg/㎡;

Base requirements:

1. The base layer should be solid and firm, not hollow, and the tensile strength should not be less than 0.5MPa;

2. The flatness error is less than 3mm (2 meters to check by ruler).

Glue preparation:

1. Pour the powder into the water and stir it into a paste, pay attention to the water first and then the powder;

2. The mixing ratio is: powder: water is 1:0.2-0.25 (the proportion of water is suitable for the best construction)

3. Stir evenly, fully mix the gouache, and there is no starch dough at all; after stirring, it must stand for 10 minutes, and then stir evenly again before use.

4. The stirred glue must be used up within 2 hours.

Tile pasting:
   
 1. Clean up the dust and release agent on the back of the tile;

2. Paint the back of the tile with this product, leave it above 25 °C for 3-4 hours, and extend the drying time below 25 °C;

3. Use a tooth scraper to extend the same direction of the base layer and the back of the tile to scrape the tile adhesive for double-sided gluing, and then knead the tile on the wall.

4. The tiles can be adjusted arbitrarily within 10 minutes, and the recommended construction thickness is 8-12mm.

Executive standard: Technical standard: JC/T547-2017 "Ceramic Tile Adhesive" C1

Environmental protection standard: GB 18583-2008 "Limit of Harmful Substances in Adhesives for Interior Decoration Materials"

Construction temperature: The construction environment temperature should be between 5°C~35°C.

Storage and transportation: Avoid direct sunlight, should be placed on the pallet and stored off the ground to prevent rainwater from soaking and avoid excessive stacking. The product has a shelf life of 12 months. Failure to follow the above storage methods may result in premature product failure or agglomeration