This product is a high-quality polymer modified dry mortar, and its adhesive performance is far superior to that of traditional cement adhesive materials. It has passed the China Ten Ring Certification and the French A+ indoor certification, and is a green and environmentally friendly product. Packing Specification: 20KG Executive Standard: GB/T 25181-2019 (indoor type I) Product Advantages: Strong adhesion,
This product is a high-quality polymer modified dry mortar, and its adhesive performance is far superior to that of traditional cement adhesive materials. It has passed the China Ten Ring Certification and the French A+ indoor certification, and is a green and environmentally friendly product.
Packing Specification: 20KG
Executive Standard: GB/T 25181-2019 (indoor type I)
Product Advantages: Strong adhesion, not easy to hollow, thin adhesive layer, light weight, low dosage.
1. The product has high strength, the national standard strength requires 0.50MPa, and the product can reach 0.6-0.9MPa.
2. Stable quality and good anti-seepage performance;
3. Just add water, simple and easy to use;
4. Strong adhesion, fast hardening speed, not easy to hollow drum;
5. The paste layer is thin, the weight is light, and the dosage is small.
Main Ingredients: Portland cement, refined sand, imported rubber powder and functional additives.
Scope of Application: It is suitable for pasting indoor ceramic bricks with a water absorption rate of ≥ 10% and a specification of ≤ 400mm*800mm.
Theoretical Dosage: 5~6kg/㎡
1. The base layer should be solid and firm, not hollow, and the tensile strength should not be less than 0.5MPa;
2. The flatness error is less than 3mm (2 meters to check by ruler).
1. Pour the powder into the water and stir it into a paste, pay attention to the water first and then the powder;
2. The mixing ratio is: powder: water is 1:0.2-0.25 (the proportion of water is suitable for the best construction)
3. Stir evenly, fully mix the gouache, and there is no starch dough at all; after stirring, it must stand for 10 minutes, and then stir evenly again before use.
4. The stirred glue must be used up within 2 hours.
1. Clean up the dust and release agent on the back of the tile.
2. Paint the back of the tile with this product, leave it above 25 °C for 3-4 hours, and extend the drying time below 25 °C;
3. Use a tooth scraper to extend the base layer and the back of the tile in the same direction as the thin scraping tile adhesive for double-sided gluing, and then Cnead the tiles against the wall.
4. The tiles can be adjusted arbitrarily within 10 minutes, and the recommended construction thickness is 8-12mm.
Executive Standard: Technical standard JC/T547-2017 "Ceramic Tile Adhesive" C1
Environmental Protection Standard: GB 18583-2008 "Limit of Harmful Substances in Adhesives for Interior Decoration Materials
Construction Temperature: The construction environment temperature should be between 5°C~35°C.
Avoid direct sunlight, should be placed on the pallet and stored off the ground to prevent rainwater from soaking and avoid excessive stacking. The product has a shelf life of 12 months. Failure to follow the above storage methods may result in premature product failure or agglomeration.